Remember the Golden Rule – Tightie Rightie, Lefty Loosey
So here it is, the piece of life changing information …… Balls are screwed tight to the right and to loosen you need to screw to the left.
Then, do both ends of a barbell unscrew?
Most barbells use threading on both ends and both balls are removable. But this is not always the case. To reduce manufacturing cost some barbells may have one of the balls permanently attached by press-fitting and it cannot be removed.
Accordingly, how do you unscrew a piercing stud?
To remove your push-pin stud, you should push the top in slightly, and then twist and pull out, while holding the back in place. Screw-in studs have a threaded top that screws into its labret. When wearing your earrings, you want to make sure these are always tightly screwed in!
How do you unscrew internally threaded jewelry?
Grab the post or other end with one hand. Grab the ball or end with your free hand. Rotate counter clockwise(righty tighty lefty loosy) and unscrew the ball or end. Once the ball or end is free, rotate the jewelry out of the piercing.
How do you remove a stuck flat back earring?
To remove your flat back earrings, hold the post (the back of the earring) with one hand and then gently unscrew the front piece from the post. Once the front piece is loose, gently pull it away from the post. Screw the front back into the post when you’re not wearing it to prevent damage to the threading.